Utah HVAC Pros
An overhead view of a residential air conditioning condenser unit mounted on a concrete pad next to a house with vinyl siding.

AC Repair in Park City, UT

If your air conditioner quits, tell us what it's doing and a licensed contractor who covers Summit County will get in touch.

Tell us about the job

It takes about a minute.

Step 1 of 3: Equipment
An outdoor air conditioning condenser unit on a concrete pad next to the gray vinyl siding of a residential home.

Park City doesn't ask much of an air conditioner

Summer afternoons here average 72°F. Most homes don't run cooling on any kind of regular schedule, and plenty go without it. That means an AC unit here isn't wearing down from long runtimes or constant cycling the way it would somewhere hot.

What it does face is weather. Summit County has logged 35 damaging wind events and a few hail events over the past ten years, including hail up to an inch. A unit sitting outside can take a hit from that, whether it's a bent fin on the coil or a wind-driven branch against the cabinet. If your AC is acting up here, it's more likely something outside got to it than something inside wore out.

72°F
the average summer afternoon it cools against
3 hail events
in ten years, and hail bends the fins on outdoor coils
35 wind events
in ten years, and wind drives debris into outdoor units
Isometric illustration of a cutaway house showing interior ductwork, an indoor air handler and furniture, connected by lines to an outdoor condenser unit on a pad.
Your air conditioner works hardest from July through August.

NOAA nClimDiv, 1991–2020 normals

Aerial view of a residential air conditioning condenser unit mounted on a concrete pad next to a house with vinyl siding and a sliding glass door.

A new air conditioner would save little on running costs in Summit County, so the repair decision comes down to the unit's condition.

  • An older air conditioner$10 a year
  • A new one at the federal minimum, 13.4 SEER2$10 a year

Estimates for a typical Summit County home, compared with an older unit built to the previous federal minimum, from EIA household energy data, Utah fuel prices and NOAA climate normals. Your home will differ.

Repair makes sense when a part like a capacitor or contactor has failed.

Replacement makes sense when the compressor has failed or the system uses R-22 refrigerant, which is no longer made.

Utah requires HVAC contractors to hold a state license.

The license is held by the contractor, not tied to any one job, and it comes from the Division of Professional Licensing after the contractor has been tested and put on record with the state. Work under $7,000 in Utah is an exception to that, so a smaller repair can legally be done without a licensed contractor.

An air conditioner repair usually means opening the refrigerant side of the system, and that part is not covered by the state license at all. It falls under federal rule, and any technician doing that work, in Summit County or anywhere else, has to hold EPA Section 608 certification.

Sources: Utah State Legislature · Utah Department of Commerce

Why is my AC not blowing cold air?
Usually it's low refrigerant from a leak, a dirty filter choking airflow, or a compressor that's failing. If the air coming out feels warm or barely moving, check the filter first since that's the one thing you can rule out yourself. Anything past that, like refrigerant, means opening the sealed system, and only a contractor with EPA Section 608 certification is allowed to do that.
Why is my AC leaking water?
Most often the condensate drain line is clogged and water is backing up instead of draining outside. It can also mean the evaporator coil has frozen over and is now melting and overflowing the pan. A dirty filter is a common cause of that freeze-up, since it blocks airflow across the coil.
Why won't my AC turn on?
Start with the thermostat, since a dead battery or wrong setting stops the whole system before it ever gets a chance to run. If the thermostat looks fine, check the breaker, since a tripped one will cut power without any other sign. Beyond that it could be a bad capacitor or a control board issue, and a contractor will need to test the unit to say which.