Furnace Installation in Huntington, UT
A new furnace here will run from October through May every year. Tell us about the house, and a licensed contractor who covers Emery County will get in touch.
Tell us about the job
It takes about a minute.
Eight months of heat a year, and nights near 19 degrees
Huntington homes need the furnace running from October through May. That's most of the year, and on the coldest nights it's holding a house against lows averaging 19°F.
Most homes here heat with gas, and any new non-weatherized gas furnace has to reach at least 80 percent AFUE by federal rule. The area has seen 54 winter storms and 17 damaging wind events over the past ten years, the kind of weather that can take out power along with the heat.
- 8 months
- October through May, your furnace is on duty
- 19°F
- the average winter night it heats against
- 59%
- of homes here heat with gas, so most furnaces here burn gas
- 80% AFUE
- the federal minimum any new unit must meet
NOAA nClimDiv, 1991–2020 normals
A high-efficiency gas furnace would save about $90 a year to run in Emery County compared with a gas furnace.
Estimates for a typical Emery County home, from EIA household energy data, Utah fuel prices and NOAA climate normals. Your home will differ.
Utah requires HVAC contractors to hold a state license.
Utah licenses HVAC contractors through the Division of Professional Licensing. The license covers the contractor, not each job, so it is the person or company doing the work who was tested and is on record with the state, not a stamp on this particular installation. Work under $7,000 falls outside that requirement, though a furnace installation is the kind of job that tends to run into it.
In most cities and counties, a furnace replacement also needs a permit from the local building office, with an inspection once the work is done. That inspection is what checks the gas connection and venting, the part of the job where a mistake is dangerous rather than just costly. Gas heats 59.4% of homes in Emery County, so that check applies to most furnaces going in here.
Sources: Utah State Legislature · Utah Department of Commerce
- What size furnace does my house need?
- There's no single answer without a load calculation, and a contractor can size it correctly by looking at your square footage, insulation, windows, and layout. Going by square footage alone is how you end up with a furnace that's too big or too small. A furnace that's oversized cycles on and off too often and wears out early. One that's undersized runs constantly and still can't keep the house warm on a 19°F night. Ask the contractor to walk you through how they calculated the size, not just tell you the number.
- How do I know it's time to replace my furnace?
- If your furnace is struggling to keep up, cycling more than it used to, or needing repairs every winter, it's worth having someone look at whether replacement makes more sense than another fix. Age matters too. Furnaces here run from October through May, eight months a year, so they log a lot of hours over their life. Rising bills without a clear reason, uneven heat between rooms, or a furnace that won't hold a set temperature are all signs the heat exchanger or other major components are wearing out. A contractor can tell you whether what you're seeing is a simple repair or the furnace nearing the end of its life.
- Is a high-efficiency furnace worth it?
- It depends on how much you heat and how long you plan to stay in the house. Since 2015, non-weatherized gas furnaces sold have to reach at least 80 percent AFUE, so even a standard model isn't inefficient anymore. High-efficiency furnaces go higher than that, meaning less heat lost out the flue. With heat needed eight months a year here, and most homes in the area heating with gas, that difference adds up over a heating season. A contractor can walk you through the actual efficiency ratings for the units they'd install and let you weigh the difference for your situation.