HVAC Installation in Huntington, UT
A new system here will heat from October through May and cool from June through August every year. Tell us about the house, and a licensed contractor who covers Emery County will get in touch.
Tell us about the job
It takes about a minute.
A new system here works nearly all year
Winter nights average 19°F from December through February, and a new furnace has to hold the house against that from October through May, eight months a year. Summer asks less of it, three months, June through August, with afternoons around 88°F. Eleven months out of the year, a home here needs one or the other.
Most homes here heat with gas, and whatever gets installed has to be sized for those 19°F nights, not an average one. Emery County has logged 54 winter storms and 17 damaging wind events over the past ten years, and about 7 percent of Utah households went at least a full day without power in 2024. A system built for a normal week here should also hold up on the nights that are not normal.
- 8 months
- October through May, your system heats
- 3 months
- June through August, it cools
- 19°F
- the average winter night it heats against
- 88°F
- the average summer afternoon it cools against
NOAA nClimDiv, 1991–2020 normals
Utah requires HVAC contractors to hold a state license.
Utah licenses HVAC contractors through the Division of Professional Licensing. That license belongs to the contractor, not to any single job, and it covers work statewide. Work under $7,000 does not need a licensed contractor, but a full heating and cooling installation runs well past that line, so the contractor doing this job needs the license.
The license is what stands behind the contractor's name here. It does not stand in for a permit. Most cities and counties in Utah require a permit for a furnace, air conditioner or heat pump installation, and an inspection once the work is done.
Sources: Utah State Legislature · Utah Department of Commerce
- When should I replace my HVAC system?
- Once your furnace or air conditioner is old enough that repairs keep coming back, or one part fails that's about as expensive to fix as the unit is worth, it's time to replace it. Winters here run cold, down to 19°F on average overnight from December through February, so a furnace that struggles in that stretch is worth watching closely. If your system is short cycling, running longer than it used to, or you're calling a contractor out more than once a season, get it looked at rather than waiting for it to fail outright in the middle of winter.
- Should I replace my furnace and air conditioner at the same time?
- If both units are close in age, replacing them together is usually the better call. Homes here need heat or cooling for 11 months of the year, so both systems are working hard and tend to wear down on a similar timeline. Replacing them at the same time also means the new furnace and air conditioner are matched to work together, which isn't always true when one is old and one is new. That said, if one unit is much newer than the other, there's no reason to replace it before it needs it. A contractor can tell you whether your two units are close enough in condition to make sense as one job.
- What happens during an HVAC installation?
- A contractor removes the old furnace and air conditioner, or heat pump, and sets the new equipment in place, then connects it to the ductwork, electrical, gas line or refrigerant lines depending on what the system needs. Once everything is connected, the contractor tests the system to make sure it's heating and cooling correctly and checks that airflow through the ducts is right for the new equipment. In Utah, installing a heating and cooling system needs a permit from the local building office, and the work gets inspected once it's done. Utah also requires the contractor doing the work to hold a state license, so it's worth confirming that before the job starts.