HVAC Installation in Blanding, UT
A new system here will heat from October through May and cool from June through August every year. Tell us about the house, and a licensed contractor who covers San Juan County will get in touch.
Tell us about the job
It takes about a minute.
Blanding asks a lot of a heating and cooling system
Winter nights here average 23°F from December through February, and homes need heat from October through May, eight months of the year. A furnace has to be sized for those cold nights, not the milder ones on either side of them.
Summer afternoons average 89°F, and cooling runs June through August. That leaves only about a month of the year when the system isn't doing one job or the other. New equipment installed here has to meet the federal minimum efficiency standard and handle both.
- 8 months
- October through May, your system heats
- 3 months
- June through August, it cools
- 23°F
- the average winter night it heats against
- 89°F
- the average summer afternoon it cools against
NOAA nClimDiv, 1991–2020 normals
Utah requires HVAC contractors to hold a state license.
The Division of Professional Licensing tests contractors before they get a license, and keeps a record of who holds one. That license belongs to the contractor, not to any single job, so it covers the business across every job it takes on. Utah does carve out one exception. Work under $7,000 does not need a licensed contractor. A full heating and cooling system installation runs well past that amount, so this job needs a licensed contractor.
A license means the contractor was tested and is on record with the state, but the installation itself still gets checked separately. Most cities and counties in Utah require a permit for a new furnace, air conditioner or heat pump, with an inspection once the work is done. That inspection is what catches a bad gas or electrical connection, the part of the job that turns dangerous if it is done wrong.
Sources: Utah State Legislature · Utah Department of Commerce
- When should I replace my HVAC system?
- Replace it when repairs get frequent or a major part fails on a system that's gotten old. In Blanding, your furnace runs from October through May, so a furnace that struggles to keep up on the 23°F nights is telling you something. Rising utility bills with no other explanation are another sign the system is losing efficiency. If a contractor is out at your house more than once a season, replacing it usually makes more sense than continuing to patch it.
- Should I replace my furnace and air conditioner at the same time?
- If both are old, yes, it's worth doing together. A furnace and air conditioner installed at different times often don't match well, and a mismatched system can run less efficiently than one sized and installed as a pair. Summers here only run June through August, so your air conditioner has an easier job than your furnace does across the eight months of heating season. Still, if one unit is much newer than the other, there's no reason to replace the one that's working.
- What happens during an HVAC installation?
- A contractor removes the old furnace and air conditioner, then sets the new equipment, connects it to your ducts, gas line or electrical circuit, and to the refrigerant lines running to the outdoor unit. They'll check the ductwork for leaks or sizing problems, since a new system connected to bad ducts won't perform the way it should. Once it's running, they test it and walk through the thermostat with you. Replacing a furnace and air conditioner in Blanding needs a permit from the local building office and an inspection when the work is done, so a licensed contractor will handle that as part of the job.