Utah HVAC Pros
Ice-covered and snow-laden tree branches in the foreground of a snowy residential street, with a house visible in the background.

HVAC Installation in Kanab, UT

A new system here will heat from October through May and cool from June through August every year. Tell us about the house, and a licensed contractor who covers Kane County will get in touch.

Tell us about the job

It takes about a minute.

Step 1 of 3: Equipment
An unfinished basement featuring concrete block walls, exposed floor joists, and a metal forced-air furnace with ductwork near a central pillar.

Eleven months of work for a new system in Kane County

Your new furnace will run from October through May, eight months of the year, on winter nights that average 23°F. Your air conditioner picks up June through August, when summer afternoons average 88°F. That leaves only a few weeks in between when the system gets to rest.

With heat needed most of the year, a furnace or heat pump sized wrong for this cold runs longer and wears faster than it should. Over half the homes here heat with electricity, so a system built for these winter lows matters even more when the grid is under strain. Kane County has logged 40 winter storms and 11 damaging wind events over the past ten years, and statewide, 7% of households lost power for at least a day in 2024. Whatever gets installed has to hold up through all of that, not just a mild afternoon.

8 months
October through May, your system heats
3 months
June through August, it cools
23°F
the average winter night it heats against
88°F
the average summer afternoon it cools against
Isometric cutaway illustration of a small house showing a furnace unit connected to ductwork running through the interior and attic, with a chimney on the shingled roof and simple furniture in the rooms.
Your system heats October through May and cools June through August.

NOAA nClimDiv, 1991–2020 normals

Utah requires HVAC contractors to hold a state license.

Utah's Division of Professional Licensing tests and licenses HVAC contractors. That license belongs to the contractor, not to any one job. It is a record the state keeps, so the person working on your system has been checked against a state standard before they get to your address. There is one exception for smaller jobs. In Utah, work under $7,000 does not need a licensed contractor. A full heating and cooling installation runs well past that, so the license applies here.

Because this is an installation, the state license is only part of what protects you. In most cities and counties, replacing a furnace, air conditioner or heat pump needs a permit from the local building office, and an inspection once the work is done. That inspection is separate from anything the state licensing board handles. It is what confirms the gas and electrical connections were made correctly, which is the part of the job that can turn dangerous if it is done wrong.

Sources: Utah State Legislature · Utah Department of Commerce

When should I replace my HVAC system?
Replace it when repairs get frequent, the system is old, or it can no longer keep the house comfortable during the coldest or hottest stretches. Winters here bring nights averaging 23°F, so a furnace that struggles in December is one you'll need to lean on for months, not just a few cold nights. A contractor can look at the age, the repair history, and how the system is actually performing in your house before you decide.
Should I replace my furnace and air conditioner at the same time?
It depends on the condition of each unit, but there are good reasons to consider doing both together. Homes here need heat from October through May and cooling from June through August, so both systems get real use every year and tend to wear on a similar timeline. If one is failing and the other is close behind, replacing them together means one installation instead of two, and a matched furnace and air conditioner work together more efficiently than a newer unit paired with an old one. A contractor can tell you where each system actually stands before you decide.
What happens during an HVAC installation?
A contractor removes the old furnace and air conditioner, or heat pump, and sets the new equipment in place, connecting it to the ductwork, the electrical supply, and the refrigerant lines. The new system gets tested to confirm it heats and cools correctly and that airflow through the ducts is right. Installing a heating and cooling system needs a permit from the local building office in most cities and counties, along with an inspection once the work is done. Utah also requires this work to be done by a licensed contractor. A contractor will price the job once they know the specifics of your house.