Water Heater Repair in Kanab, UT
Tell us what your water heater is doing, and a licensed contractor who covers Kane County will get in touch.
Tell us about the job
It takes about a minute.
Kanab winters put a strain on your water heater that lasts eight months
Your water heater works harder from October through May, heating incoming water that starts out cold. On nights near 23°F, the ground and pipes feeding it run cold too, so the burner or heating element stays on longer to hold the same temperature at the tap.
That extra runtime wears on the parts that do the heating. A gas water heater's igniter and burner cycle more often, and the anode rod and heating elements in an electric unit wear down faster with the added load. You notice it as water that takes longer to heat back up, or a tank that runs out faster than it used to.
- 23°F
- the average winter night, and colder incoming water means longer heating
- 8 months
- October through May, the months homes here need heat
- 7%
- of Utah households lost power for a day or more in 2024, and a heater with an electric element or electric ignition stops without it
NOAA nClimDiv, 1991–2020 normals
A new water heater would cut about $230 a year off hot water for a typical Utah home.
Estimates for a typical Utah home, compared with an older unit built to the federal minimum, from EIA household energy data and Utah fuel prices. Your home will differ.
Repair makes sense when an element, thermostat or gas valve has failed.
Replacement makes sense when the tank itself is leaking.
- Why is my water heater leaking from the bottom?
- Most of the time this means the tank itself has failed. Water heater tanks corrode from the inside over years, and once a hole opens up in the steel, water works its way down and out the bottom. Water pooling under the tank can also come from a loose drain valve or a fitting at the bottom, so it's worth checking those first since they're an easy fix. If the tank itself is rusted through, the unit needs to be replaced, not repaired, and a contractor can confirm which one it is.
- Why won't the pilot light on my water heater stay lit?
- The most common cause is a worn out thermocouple, the small part that sits in the pilot flame and signals the gas valve to stay open. When it wears out, it stops sensing the flame correctly and shuts the gas off even though the pilot is lit. A dirty pilot orifice or a draft blowing the flame around can cause the same thing, so it's not always the thermocouple. A standing pilot doesn't run on electricity, so a power outage isn't the cause. This is a gas control issue and shouldn't be worked around, a contractor can pin down which part is failing.
- Can a tankless water heater be repaired?
- Yes, most tankless water heater problems are repairable. Common issues are a clogged inlet filter, a buildup of mineral scale on the heat exchanger, or a failed igniter, and all of these can be serviced without replacing the unit. Error codes on the display usually point straight to which part is causing the trouble. Whether it makes more sense to repair or replace comes down to the age of the unit and what's actually failed, which a contractor can assess in person.