HVAC Installation in Richfield, UT
A new system here will heat from September through June and cool from July through July every year. Tell us about the house, and a licensed contractor who covers Sevier County will get in touch.
Tell us about the job
It takes about a minute.
Ten months of heat, one month of cooling, same system
Richfield needs heat from September through June. Winter nights average 17°F, cold enough that a furnace has to hold up night after night with little recovery time. A new system has to be sized for that stretch, not just the coldest week of it.
July is the only month built around cooling, with afternoons averaging 78°F. That is a short season, but the same equipment has to handle it, so the install has to work for both jobs, not just the one that runs longer.
- 10 months
- September through June, your system heats
- 1 months
- July through July, it cools
- 17°F
- the average winter night it heats against
- 78°F
- the average summer afternoon it cools against
NOAA nClimDiv, 1991–2020 normals
Utah requires HVAC contractors to hold a state license.
Utah tests HVAC contractors before they're licensed, and that license is on record with the Division of Professional Licensing. It covers the contractor, not the job in front of you, so it tells you the person or company met the state's standard, not that this particular install was done right. Utah also draws a line at $7,000. Work under that doesn't need a licensed contractor, but a full heating and cooling system install almost always runs past that number, which puts this job on the licensed side of the line.
Most cities and counties in Utah also require a permit for a job like this, plus an inspection once it's finished. That means someone from the local building office checks the finished work separately from anything the state license covers. Between the state testing the contractor and the local office checking the install itself, this job gets looked at from both ends.
Sources: Utah State Legislature · Utah Department of Commerce
- When should I replace my HVAC system?
- Replace it when repairs get frequent, the equipment is old, or it can no longer keep up on the coldest or hottest days. An aging furnace or air conditioner works harder to do what it used to do easily, and that shows up as higher bills or a system that runs longer to reach the same temperature. Homes here need heat from September through June, so a furnace that struggles to keep up matters most on a night near 17°F. If a repair bill starts to rival what a new system would cost, that is usually the sign to stop patching it.
- Should I replace my furnace and air conditioner at the same time?
- If both are old or failing, replacing them together makes sense, but it is not required. A furnace and air conditioner installed at the same time are matched to work together, and a contractor can size each one correctly for the house. If one unit is still working well, a contractor can look at the age and condition of each and tell you whether replacing both now or waiting on one makes sense for your situation.
- What happens during an HVAC installation?
- A contractor removes the old furnace, air conditioner, or heat pump, sets the new equipment in place, and connects it to the existing ducts, gas line or refrigerant lines, and electrical. The new unit gets tested to confirm it heats or cools correctly and that the thermostat and safety controls work. In most cities and counties, this work needs a permit from the local building office, and an inspector checks it once it is done. Utah requires HVAC contractors to hold a state license, and installing a heating and cooling system falls well above the threshold where unlicensed work is allowed. A contractor will price the job once they see the house.