HVAC Installation in Price, UT
A new system here will heat from September through May and cool from July through July every year. Tell us about the house, and a licensed contractor who covers Carbon County will get in touch.
Tell us about the job
It takes about a minute.
Nine months of heat, one month of real cooling
Winter nights here average 15°F from December through February, and homes need heat from September through May. That is nine months of the year for a furnace to carry. Cooling only comes into it in July, when afternoons average 80°F, so the air conditioner side of a new system has less work to do, but it still has to be sized for that month.
Most homes here heat with gas, and a furnace running this many months a year has to meet the federal minimum efficiency rating. The area has logged 29 winter storms over the past ten years, and in Utah, 7% of households went at least 24 hours without power in 2024. A gas furnace with a standing pilot will relight on its own once power comes back. One with electronic ignition needs power to start.
- 9 months
- September through May, your system heats
- 1 months
- July through July, it cools
- 15°F
- the average winter night it heats against
- 80°F
- the average summer afternoon it cools against
NOAA nClimDiv, 1991–2020 normals
Utah requires HVAC contractors to hold a state license.
The license comes from the Division of Professional Licensing, and it covers the contractor, not the job itself. Utah does carve out an exception. Work under $7,000 does not need a licensed contractor. A full heating and cooling system installation runs well past that figure, so this job falls under the license requirement.
Most cities and counties in Utah also require a permit for this kind of installation, along with an inspection once the work is done. That permit and inspection come from the local building office, separate from the state license. The license says the contractor is allowed to do this work. The inspection is what checks the job itself once it is installed.
Sources: Utah State Legislature · Utah Department of Commerce
- When should I replace my HVAC system?
- Replace it when repairs start costing more than they're worth or when the system can't keep up anymore. A furnace or air conditioner past 15 years old is working harder than it used to, and with nine months of the year here needing heat, a furnace that struggles in December is only going to get worse by February. Watch for signs like uneven temperatures room to room, a system that runs constantly, or a repair bill that keeps climbing. If your equipment is old and just gave out, that's usually the clearest sign it's time.
- Should I replace my furnace and air conditioner at the same time?
- If both are old, yes, it usually makes sense. A furnace and air conditioner installed at the same time are matched to work together, and since summers here are short and mild but winters run nine months, your furnace does most of the work and wears down faster. Replacing only one means pairing new equipment with an aging system that may not be far behind it. A contractor can look at the age and condition of both and tell you whether replacing them together makes sense for your house.
- What happens during an HVAC installation?
- A contractor removes the old furnace, air conditioner, or both, and sets the new equipment in place, connecting it to your ductwork, gas line or electrical circuit, and the vent or flue. They check refrigerant lines, wiring, and airflow, then run the system through a full heating and cooling cycle to make sure it's working right. In most cities and counties, this job needs a permit from the local building office along with an inspection once the work is done. Utah also requires the contractor doing the work to hold a state license. A contractor will price the job once they see the house.