HVAC Installation in Tooele, UT
A new system here will heat from October through May and cool from June through August every year. Tell us about the house, and a licensed contractor who covers Tooele County will get in touch.
Tell us about the job
It takes about a minute.
A system built for eleven months of work
Tooele County homes need heat or cooling eleven months of the year. Furnaces run October through May, and winter nights average 20°F from December through February, cold enough that a furnace put in this year will run long hours most nights it works. Summer afternoons average 89°F, and for three months, June through August, the air conditioner is what keeps the house livable.
Most homes here heat with gas, so whatever goes in has to be sized for both jobs, not just one. Wind is part of the picture too. The county has logged 497 damaging wind events and 14 winter storms over the past ten years, and outages follow storms like these. Statewide, 7% of households went at least 24 hours without power last year. A new system should start back up on its own once the power does, without anyone having to relight it.
- 8 months
- October through May, your system heats
- 3 months
- June through August, it cools
- 20°F
- the average winter night it heats against
- 89°F
- the average summer afternoon it cools against
NOAA nClimDiv, 1991–2020 normals
Utah requires HVAC contractors to hold a state license.
The Division of Professional Licensing tests and records the contractor who holds this license. It covers the contractor, not the specific job at your house. Utah does carve out an exception. Work under $7,000 does not need a licensed contractor. A full heating and cooling system install almost always runs past that number, so the contractor doing this job should be the licensed one.
The license covers who is allowed to do the work. It does not cover whether this particular installation was done right. That comes from your local building office. Replacing a furnace, air conditioner or heat pump needs a permit in most cities and counties, and an inspector checks the work once it is done. That inspection is where a bad gas connection or a wiring mistake gets caught, separate from anything the state license already vouched for.
Sources: Utah State Legislature · Utah Department of Commerce
- When should I replace my HVAC system?
- Look at the age and the repair record first. A furnace or air conditioner that keeps needing repairs and is getting old is usually cheaper to replace than to keep patching. Homes here need heat or cooling 11 months out of the year, so a system that struggles during that stretch is going to keep costing you. If yours is shutting down on the cold nights or short-cycling in the heat, that is the sign to stop repairing and start planning a replacement.
- Should I replace my furnace and air conditioner at the same time?
- If both are old, yes, that is usually the better time to do it. A furnace and air conditioner installed together are matched to work as one system, and a contractor can size both to your ductwork at once instead of guessing how a new unit will pair with an old one. It also means one job, one permit, and one inspection instead of two separate ones down the road. If only one is failing and the other is still working fine, replacing just the one that needs it is reasonable too. A contractor can look at both and tell you what makes sense for your house.
- What happens during an HVAC installation?
- The contractor removes the old furnace and air conditioner and sets the new ones in place, then connects them to your ductwork, gas line, electrical, and condensate drain. The refrigerant lines get run to the outdoor unit and the whole system gets charged and tested before the contractor walks you through it. This job needs a permit from the local building office, and an inspector checks the work once it is done. The contractor should hold a Utah HVAC license to do the job. A contractor will price the work for your specific house once they see what is involved.