HVAC Installation in Ogden, UT
A new system here will heat from September through June and cool from July through August every year. Tell us about the house, and a licensed contractor who covers Weber County will get in touch.
Tell us about the job
It takes about a minute.
A system that has to work almost all year
Weber County needs heat ten months a year, September through June, with winter nights averaging 19°F. That is a long stretch for a furnace to carry, and most homes here run on gas to do it. Summer is short by comparison, just July and August, but those afternoons average 81°F, and the system still has to handle that heat when it comes.
A new furnace or air conditioner installed here has to be sized for both ends of that range, the 19°F low and the 81°F high, not just whichever season you're replacing it in. Whatever gets installed also has to meet the federal minimum efficiency rating in place at the time, so the equipment on the market today is already built to that standard.
- 10 months
- September through June, your system heats
- 2 months
- July through August, it cools
- 19°F
- the average winter night it heats against
- 81°F
- the average summer afternoon it cools against
NOAA nClimDiv, 1991–2020 normals
Utah requires HVAC contractors to hold a state license.
The Division of Professional Licensing tests and licenses HVAC contractors in Utah. That license belongs to the contractor, not to any single job. Work under $7,000 is the one carve-out the state makes. Below that dollar amount, the job does not require a licensed contractor. A full heating and cooling system installation runs well past that line, so the license is what applies here.
Since Utah licenses the contractor for this kind of job, that license is the thing standing behind the work. Beyond it, the local building office has its own role. In most cities and counties, putting in a new furnace, air conditioner or heat pump needs a permit from that office, and an inspection once the work is done.
Sources: Utah State Legislature · Utah Department of Commerce
- When should I replace my HVAC system?
- Replace it when the furnace or air conditioner is breaking down more than once a season, or when a contractor tells you the heat exchanger or coil has failed. Age matters too. A furnace working hard for 10 months of heating a year here wears faster than one running just a few weeks in a milder climate. If a repair keeps coming up on the same aging unit, that is usually the sign to stop patching it and replace it instead.
- Should I replace my furnace and air conditioner at the same time?
- If both are near the end of their life, yes, because a contractor can size the new furnace and coil to work together instead of pairing an old unit with a new one. But if your air conditioner is still young and only the furnace has failed, there is no reason to replace a working system early. With only two months of real cooling need here against ten months of heating, the furnace is doing most of the work in most homes, so that is usually the one that wears out first.
- What happens during an HVAC installation?
- A contractor removes the old furnace and air conditioner or heat pump, sets the new equipment in place, and connects it to the existing ducts, gas line or electrical circuit, and refrigerant lines. They check the ductwork for leaks or sizing problems before closing everything up, since a new system connected to bad ducts will not perform the way it should. This job needs a permit from the local building office and an inspection when the work is finished, and it needs a licensed contractor, since installing a heating and cooling system runs well past the point where Utah allows unlicensed work. A contractor will price the job once they see the house.