Water Heater Repair in Ogden, UT
Tell us what your water heater is doing, and a licensed contractor who covers Weber County will get in touch.
Tell us about the job
It takes about a minute.
Weber County winters push your water heater hard
Your water heater works nearly all year here, since homes need heat from September through June. On winter nights averaging 19°F, incoming water runs cold, so the burner or heating element has to work harder and longer to get a tank of water hot. That extra runtime wears on the thermostat and the heating element in an electric unit, or the burner assembly and thermocouple in a gas one.
Weber County has seen 60 winter storms and 81 damaging wind events over the past ten years, and storms like these can knock out power. Most water heaters come back on by themselves once power returns, but a gas unit with a standing pilot will need that pilot relit by hand. If your water isn't heating after an outage, that is the first thing worth checking.
- 19°F
- the average winter night, and colder incoming water means longer heating
- 10 months
- September through June, the months homes here need heat
- 7%
- of Utah households lost power for a day or more in 2024, and a heater with an electric element or electric ignition stops without it
NOAA nClimDiv, 1991–2020 normals
A new water heater would cut about $80 a year off hot water for a typical Utah home.
Estimates for a typical Utah home, compared with an older unit built to the federal minimum, from EIA household energy data and Utah fuel prices. Your home will differ.
Repair makes sense when an element, thermostat or gas valve has failed.
Replacement makes sense when the tank itself is leaking.
- Why is my water heater leaking from the bottom?
- The tank itself has likely rusted through from the inside and started to leak, which means it needs to be replaced rather than repaired. Water heaters corrode from the inside out over years of use, and once the tank wall is breached there's no patch that holds. A leak at the bottom can also come from the drain valve or from fittings above the tank running water down the side, so it's worth checking those before assuming the tank is done. A contractor can tell you which one it is and what your options are.
- Why won't the pilot light on my water heater stay lit?
- The most common cause is a worn thermocouple, the small sensor that tells the gas valve the pilot is burning. When it wears out or sits out of position, it shuts the gas off even though the flame is lit, so the pilot goes out again soon after you release the knob. A dirty pilot tube or a draft near the burner can cause the same thing. A standing pilot doesn't use any electricity, so a power outage isn't the cause here. A contractor can test the thermocouple and replace it if that's the problem.
- Can a tankless water heater be repaired?
- Yes, most tankless water heater problems can be repaired without replacing the whole unit. Common issues are a clogged inlet filter, a buildup of scale on the heat exchanger, or a failed igniter, and each of those can be cleaned or replaced on its own. The exchanger itself is the most expensive part, so if that's what's failed, a contractor will walk you through whether repair or replacement makes more sense for your unit.