Furnace Installation in Ogden, UT
A new furnace here will run from September through June every year. Tell us about the house, and a licensed contractor who covers Weber County will get in touch.
Tell us about the job
It takes about a minute.
Ten months of heat a year in Weber County
Furnaces here run from September through June. That is ten months of the year, with only a short stretch of summer off. Winter nights average 19°F, so a new furnace spends most of the season working, not idling.
Most homes in Weber County heat with gas, and any non-weatherized gas furnace made today has to reach at least 80 percent AFUE. That is the federal minimum, not a feature. The area has also seen 60 winter storms and 81 damaging wind events over the past ten years, the kind of weather that knocks out power and puts a furnace to the test on the coldest nights.
- 10 months
- September through June, your furnace is on duty
- 19°F
- the average winter night it heats against
- 83%
- of homes here heat with gas, so most furnaces here burn gas
- 80% AFUE
- the federal minimum any new unit must meet
NOAA nClimDiv, 1991–2020 normals
A high-efficiency gas furnace would save about $110 a year to run in Weber County compared with a gas furnace.
Estimates for a typical Weber County home, from EIA household energy data, Utah fuel prices and NOAA climate normals. Your home will differ.
Utah requires HVAC contractors to hold a state license.
The license comes from the Division of Professional Licensing. It is tied to the contractor, not the job itself. The state tested that contractor and keeps a record of them. Work under $7,000 does not legally require a licensed contractor, but a furnace installation runs well past that line, so the license requirement applies here.
Most cities and counties also require a permit from the local building office for a furnace installation, with an inspection once the work is done. That permit is separate from the license and comes from the city or county, not the state. Furnace installation involves a gas connection, and the inspection is what checks that connection before the job is considered done. In Weber County, most homes heat with gas, so this is the kind of job that permit and inspection process exists for.
Sources: Utah State Legislature · Utah Department of Commerce
- What size furnace does my house need?
- The right size depends on your square footage, your insulation, your windows, and your home's layout, so it takes a load calculation to get a real answer. A furnace that's too big will short cycle, heating fast then shutting off before it warms the house evenly. One that's too small will run nonstop trying to keep up, especially on a 19°F night. A contractor can run this calculation for your house and size the job correctly.
- How do I know it's time to replace my furnace?
- If your furnace is struggling to keep rooms warm, cycling on and off more than it used to, or needing repairs more often, it's telling you something. Age matters too. A furnace pushed hard for 10 months of the year, September through June, wears differently than one that only runs a few months. If a repair bill starts approaching what a new unit would run, replacement usually makes more sense than another patch job. A contractor can look at the actual unit and tell you where it stands.
- Is a high-efficiency furnace worth it?
- It depends on how much your furnace runs and what you're replacing. Here, homes need heat from September through June, so a furnace here logs a lot more hours than one in a milder climate. Every non-weatherized gas furnace built since November 2015 has to hit at least 80 percent AFUE, so even a standard new unit is already fairly efficient. A high-efficiency model above that pulls more heat out of the same fuel, and with 82.9 percent of homes here heating with gas, that difference adds up over 10 months of runtime. A contractor can walk you through the actual models and where the payoff lands for your house.