Furnace Installation in Morgan, UT
A new furnace here will run from September through June every year. Tell us about the house, and a licensed contractor who covers Morgan County will get in touch.
Tell us about the job
It takes about a minute.
Ten months of heat a year in Morgan
Winter nights here average 17°F, and homes need heat from September through June. That is ten months of the year the furnace has to work, not just the deep winter stretch. A furnace sized and installed for this has to hold up to a long season, not a short one.
Most homes in Morgan heat with gas, and any new non-weatherized gas furnace installed today has to reach at least 80 percent AFUE, the federal minimum. Winters here also bring storms, 47 of them over the last ten years along with 16 damaging wind events, the kind of weather that knocks out power. When that happens, a furnace that depends on electricity to run its blower and controls will not put out heat until power is back.
- 10 months
- September through June, your furnace is on duty
- 17°F
- the average winter night it heats against
- 91%
- of homes here heat with gas, so most furnaces here burn gas
- 80% AFUE
- the federal minimum any new unit must meet
NOAA nClimDiv, 1991–2020 normals
A high-efficiency gas furnace would save about $120 a year to run in Morgan County compared with a gas furnace.
Estimates for a typical Morgan County home, from EIA household energy data, Utah fuel prices and NOAA climate normals. Your home will differ.
Utah requires HVAC contractors to hold a state license.
The Division of Professional Licensing tests and records HVAC contractors in Utah, and that license belongs to the contractor, not to any one job. Work under $7,000 falls outside that requirement, so smaller jobs can be done without a licensed contractor. A furnace installation runs well past that line, so the contractor doing the work should hold that license.
The license covers who is allowed to do the work. In most cities and counties, a furnace installation also needs a permit from the local building office and an inspection once the job is done, and that inspection is where the gas connection and venting get checked. That is separate from the license, and it is what confirms the installation itself was done safely. Most homes in Morgan County heat with gas, which is why that check matters here.
Sources: Utah State Legislature · Utah Department of Commerce
- What size furnace does my house need?
- It depends on your home's square footage, ceiling height, insulation, window count, and layout, so there's no single number that fits every house. A contractor works this out with a load calculation, not a chart based on square footage alone. With winter lows here averaging 17°F, getting this right matters more than in milder places. A furnace that's too big will short cycle and wear out early. One that's too small will run constantly and still leave rooms cold.
- How do I know it's time to replace my furnace?
- Watch for repairs that keep coming back, a furnace that's old enough that parts are wearing out, or rooms that won't hold heat no matter what you set the thermostat to. Rising gas bills with no other explanation are another sign the unit is losing efficiency. Homes here need heat from September through June, so a failing furnace has very little time each year to rest and recover, which can speed up wear. If a contractor tells you a repair costs a large share of what a new furnace would, replacement is usually the better move.
- Is a high-efficiency furnace worth it?
- For a home that runs its furnace 10 months a year, the extra efficiency has more time to pay off here than in a place with a short heating season. Furnaces made since November 2015 have to hit at least 80 percent AFUE, and high-efficiency models go higher than that, meaning less gas burned for the same heat. Since 91.4 percent of homes in Morgan County heat with gas, that efficiency difference shows up directly on the gas bill. A contractor can walk through the options and what fits your house, since the actual cost and payback depend on the specific installation.