HVAC Installation in Logan, UT
A new system here will heat from September through June and cool from July through July every year. Tell us about the house, and a licensed contractor who covers Cache County will get in touch.
Tell us about the job
It takes about a minute.
A system that has to carry most of the year
In Logan, heat is the main job. Winter nights average 17°F from December through February, and homes here need heat from September through June, ten months of the year. Whatever you install has to hold up to a long, cold season, not just a few weeks of it.
Summer asks less of it. Afternoons average 78°F, and cooling season here runs about one month. That's still worth planning for, but the furnace or heat pump you choose is doing the heavier work most of the year. Most homes in Cache County heat with gas, and a new system installed here has to meet the federal minimum efficiency rating for the equipment type.
- 10 months
- September through June, your system heats
- 1 months
- July through July, it cools
- 17°F
- the average winter night it heats against
- 78°F
- the average summer afternoon it cools against
NOAA nClimDiv, 1991–2020 normals
Utah requires HVAC contractors to hold a state license.
The Division of Professional Licensing tests and keeps records on the contractor, not on each job they do. Utah does carve out an exception for small work. Anything under $7,000 does not require a licensed contractor. A full heating and cooling installation runs well past that line, so this is a licensed job.
For a job like this, the state license is what stands behind the person doing the work. Beyond that, most cities and counties in Utah require a permit before a furnace, air conditioner or heat pump goes in, and an inspection once the work is done. That inspection is a separate check from the license, done by the local building office, and it is what catches a bad gas connection or a wiring mistake before the system runs for years unchecked.
Sources: Utah State Legislature · Utah Department of Commerce
- When should I replace my HVAC system?
- Replace it when repairs start costing too much or the system can't keep up anymore. An aging furnace that needs a major repair, or an air conditioner that's low on refrigerant and getting old, is usually a sign to stop repairing and start planning ahead. In Logan, the furnace runs September through June, so it carries most of the load and wears accordingly. A rising gas bill or rooms that won't heat evenly are both signs the system is losing ground.
- Should I replace my furnace and air conditioner at the same time?
- If they're close in age, yes. Furnaces and air conditioners installed together are matched to work as a system, and pairing a new furnace with an old air conditioner can mean the new unit never runs at its rated efficiency. Homes in Logan lean on the furnace far more than the air conditioner, with summer afternoons averaging 78°F, so if the air conditioner still runs fine and the furnace is failing, replacing just the furnace can make sense. A contractor can look at the age and condition of both and tell you whether pairing them is worth it for your house.
- What happens during an HVAC installation?
- A contractor removes the old furnace and air conditioner or heat pump, then sets the new equipment in place and connects it to the ductwork, gas line or electrical circuit, and the condensate drain. After that comes startup, where the system is checked for correct airflow, refrigerant charge, and safe operation. In most cities and counties, this job needs a permit from the local building office and an inspection once the work is done. Installing a heating and cooling system is well above the point where Utah law requires a licensed contractor, so whoever does the work should hold a state license through the Division of Professional Licensing. A contractor will price the job once they've seen the house.