Utah HVAC Pros
A snow-covered craftsman house at night with one illuminated window and an attached two-car garage.

HVAC Repair in Vernal, UT

Homes here need heat from September through May and cooling from July through August. If your system quits, tell us what it's doing and a licensed contractor who covers Uintah County will get in touch.

Tell us about the job

It takes about a minute.

Step 1 of 3: Equipment
A gray forced-air furnace with sheet-metal ductwork stands in an unfinished basement with exposed wooden joists, concrete walls, and a hanging incandescent bulb.

Nine months of heat, and nights near 13 below zero

Your furnace in Vernal works from September through May. That is nine months of the year, with winter nights averaging 13°F from December through February. At that temperature the furnace runs long stretches to hold the house, and the igniter and blower motor take the wear. When one of those gives out, you find out on the coldest night, not a mild one.

Summer is short here, just July and August, but afternoons average 84°F and the air conditioner has to answer for it. Uintah County has seen 58 winter storms and 36 damaging wind events over the past ten years, and storms like that knock out power. Across Utah, 7% of households lost power for a full day or more in 2024. Most furnaces and air conditioners come back on by themselves once power returns, but a system already struggling may not start clean.

9 months
September through May, your system heats
2 months
July through August, it cools
13°F
the average winter night it heats against
84°F
the average summer afternoon it cools against
Isometric cutaway illustration of a small house with a dark shingled roof, showing an interior furnace unit, ductwork, and a flue pipe extending through the roof.
Your system heats September through May and cools July through August.

NOAA nClimDiv, 1991–2020 normals

An unfinished basement featuring concrete block walls, exposed floor joists, and a metal forced-air furnace with ductwork near a central pillar.

A new furnace and air conditioner would cut about $140 a year off heating and cooling for a typical Uintah County home.

  • A new furnace and AC$680 a year
  • An older furnace and AC$820 a year

Estimates for a typical Uintah County home, compared with an older unit built to the previous federal minimum, from EIA household energy data, Utah fuel prices and NOAA climate normals. Your home will differ.

Repair makes sense when one part has failed.

Replacement makes sense when the furnace's heat exchanger is cracked, the air conditioner's compressor has failed, or repairs keep coming.

Utah requires HVAC contractors to hold a state license.

The Division of Professional Licensing tests and records the contractor before that license is issued, and it stays tied to the contractor rather than to any single job. In Utah, work under $7,000 falls outside that requirement, so a repair below that amount can be done without a licensed contractor.

For a heating and cooling repair above that amount, the license is what stands behind the person doing the work, since Utah puts the testing and the record at the state level rather than leaving it to the county or the job. Below $7,000, that state check does not apply, and the license is the only protection this rule names either way.

Sources: Utah State Legislature · Utah Department of Commerce

Why is my heat not working?
Start with the thermostat. Make sure it's set to heat and the set temperature is above the room temperature, and check if the display is blank, which usually means a dead battery. If the thermostat looks fine, check your breaker panel for a tripped breaker, since a furnace that won't even click on often has no power getting to it. Gas furnaces also have a pilot light or an igniter, and if the pilot went out or the igniter failed, the furnace won't fire even with power and a good thermostat setting. Winter nights here drop to 13°F on average, so a furnace that's down for even a few hours is worth getting a contractor out for.
Why is my system running but not cooling the house?
Check the air filter first. A filter clogged with dust blocks airflow across the indoor coil, and when air can't move past it, the house won't cool even though the system is running. Next check the outdoor unit and clear away any leaves, dirt, or grass clippings blocking the coil, since it needs open airflow to release the heat pulled from inside. If the filter is clean and the outdoor unit is clear but the air coming from your vents isn't cold, that points to a refrigerant leak or a failing compressor, and that's a job for a licensed contractor.
What can I check before calling for HVAC repair?
Check the thermostat settings and battery, the air filter, and your breaker panel before anything else. These are the most common reasons a system won't heat or cool, and each one takes just a minute to look at. Also check the outdoor unit for debris or ice buildup, since either one restricts the airflow the system needs to work properly. If everything checks out and the system still isn't heating or cooling, a licensed contractor can diagnose what's wrong and price the repair for your house.