HVAC Installation in Heber, UT
Tell us about the house, and a licensed contractor who covers Wasatch County will get in touch.
Tell us about the job
It takes about a minute.
Ten months of heat, and nights that drop to 14°F
Your new system has to earn its keep in Heber. Winter nights average 14°F from December through February, and homes here need heat from September through June, ten months a year. That is a long season for a furnace to run and a lot of nights where it has to work hard. Summer afternoons average 75°F, mild enough that cooling is not the main job here.
Most homes in the area heat with gas. Whatever you install, it needs to be sized for those 14°F nights, not just a mild day, so it can keep the house warm when the temperature actually drops.
- 10 months
- September through June, your system heats
- 14°F
- the average winter night it heats against
- 75°F
- the average summer afternoon it cools against
Utah requires HVAC contractors to hold a state license.
The Division of Professional Licensing tests and licenses HVAC contractors in Utah, and that license belongs to the contractor, not to any single job. Work under $7,000 does not require a licensed contractor. A full heating and cooling installation runs well past that, so the state expects a licensed contractor on this job.
A license tells you the state has tested this contractor and keeps a record of them, but it does not inspect the installation itself. That comes from the local building office. In most cities and counties in Utah, putting in a new furnace or air conditioner needs a permit before the work starts and an inspection once it is done, and that inspection is what checks the gas connections, the wiring and the refrigerant lines are put together right.
Sources: Utah State Legislature · Utah Department of Commerce
- When should I replace my HVAC system?
- Replace it when repairs keep coming, it can't hold the temperature you set, or it can't keep up on the coldest nights. Homes in Heber need heat from September through June, so a furnace has to carry most of the year here, including nights that average 14°F in December through February. If yours is short-cycling, running longer than it used to, or needing a repair call more than once a season, have a contractor look at it before you're stuck deciding during a cold snap.
- Should I replace my furnace and air conditioner at the same time?
- If both are old, it usually makes sense to replace them together. A furnace and air conditioner installed at the same time are matched to work with each other, and a lot of the labor to open up the system is shared between the two jobs. Most homes in Heber heat with gas and get little use out of the air conditioner, since cooling season here runs zero months, so if your AC is newer or barely used there's less reason to swap it out just because the furnace needs work. A contractor can look at the age and condition of each system and tell you honestly whether doing both makes sense for your house.
- What happens during an HVAC installation?
- A contractor removes the old furnace and air conditioner, or heat pump, and sets the new equipment in place, connecting it to the ductwork, gas line, electrical, and condensate drain. They check the ducts and vents against the new unit's airflow needs and make adjustments if something doesn't match up. Once it's running, they test it through a full cycle and check the settings before calling the job done. In most cities and counties, this kind of installation needs a permit from the local building office and an inspection when the work is finished, so expect that as part of the process.