Utah HVAC Pros
A brushed steel rain shower head running hot water with steam rising in a grey tiled shower enclosure.

Water Heater Repair in Heber, UT

Tell us what your water heater is doing, and a licensed contractor who covers Wasatch County will get in touch.

Tell us about the job

It takes about a minute.

Step 1 of 3: Equipment
A chrome two-handle bathroom faucet dispensing steaming hot water into a white sink.

Cold water for ten months a year wears on your water heater in Heber

Homes here need heat from September through June, ten months a year. That same cold is dropping the temperature of the water coming into your tank, so the burner or heating element has to run longer to bring it up to temperature. Longer run times wear on the parts that make the heat.

A heating element that is failing or a burner that will not hold a flame usually shows up as water that never gets fully hot, or hot water that runs out sooner than it used to. If the power goes out, most tanks come back on by themselves once it is restored, but a gas water heater with a standing pilot will need that pilot relit by hand.

14°F
the average winter night, and colder incoming water means longer heating
10 months
September through June, the months homes here need heat
7%
of Utah households lost power for a day or more in 2024, and a heater with an electric element or electric ignition stops without it
Isometric cutaway illustration of a small house with a dark shingled roof, showing interior rooms with a bed, bathtub, sinks, and a cylindrical water heater connected to pipes and a tall vent stack.
Your water heater works hardest from October through April.

NOAA nClimDiv, 1991–2020 normals

A stainless steel faucet pours a stream of hot water surrounded by rising steam.

A new water heater would cut about $80 a year off hot water for a typical Utah home.

  • A heat pump water heater$130 a year
  • A new high-efficiency gas water heater$180 a year
  • An older gas water heater$260 a year

Estimates for a typical Utah home, compared with an older unit built to the federal minimum, from EIA household energy data and Utah fuel prices. Your home will differ.

Repair makes sense when an element, thermostat or gas valve has failed.

Replacement makes sense when the tank itself is leaking.

Why is my water heater leaking from the bottom?
The most common cause is the tank itself corroding from the inside and starting to seep. Sediment builds up on the bottom of the tank over years, and once it wears through the lining, water finds a way out. A leak can also come from a loose drain valve or a fitting on the bottom of the unit, which a contractor can check before writing off the tank. If the leak is from the tank itself, there is no patch or seal that fixes it, and the unit needs to be replaced.
Why won't the pilot light on my water heater stay lit?
Most often the thermocouple has worn out and no longer tells the gas valve the pilot is lit, so the valve shuts the gas off. A dirty or clogged pilot orifice can cause the same problem by starving the flame. Wind or a draft near the unit can also blow a pilot out repeatedly if it is not sealed. A gas water heater with a standing pilot does not need power to run, so a loss of electricity is never the cause.
Can a tankless water heater be repaired?
Yes, most problems with a tankless water heater are repairable rather than a reason to replace it. A clogged inlet filter, a buildup of scale on the heat exchanger, or a failed igniter are common issues a contractor can fix. Error codes on the unit's display usually point straight to the part causing trouble. Replacement only comes up when the heat exchanger itself has failed or the unit is old enough that parts are hard to find.