Water Heater Repair in Roosevelt, UT
Tell us what your water heater is doing, and a licensed contractor who covers Duchesne County will get in touch.
Tell us about the job
It takes about a minute.
Cold winters put the load on your water heater
Homes here need heat from September through June, ten months out of the year, and your water heater is running through most of that same stretch. That steady demand falls on the heating element or the gas burner, and that's usually the first part to wear out, showing up as water that takes longer to heat or doesn't get as hot as it used to.
Duchesne County has seen 53 winter storms and 25 damaging wind events over the past ten years, and weather like that brings power outages with it. Most water heaters come back on by themselves once power is restored. If yours doesn't fire back up, that's a sign something else needs a look.
- 12°F
- the average winter night, and colder incoming water means longer heating
- 10 months
- September through June, the months homes here need heat
- 7%
- of Utah households lost power for a day or more in 2024, and a heater with an electric element or electric ignition stops without it
NOAA nClimDiv, 1991–2020 normals
A new water heater would cut about $80 a year off hot water for a typical Utah home.
Estimates for a typical Utah home, compared with an older unit built to the federal minimum, from EIA household energy data and Utah fuel prices. Your home will differ.
Repair makes sense when an element, thermostat or gas valve has failed.
Replacement makes sense when the tank itself is leaking.
- Why is my water heater leaking from the bottom?
- Most often the tank itself has rusted through from the inside and is starting to fail. Sediment builds up at the bottom of the tank over years and traps moisture against the steel, and once it rusts through, the leak will not stop or seal itself. It can also be a loose drain valve or a fitting that has worked itself loose, which a contractor can check before assuming the tank is done. If the water is coming from the tank body itself, the water heater needs to be replaced, not patched.
- Why won't the pilot light on my water heater stay lit?
- The most common cause is a worn thermocouple, the small sensor that tells the gas valve the pilot is burning. When it wears out, it fails to signal the flame is present, and the gas valve shuts off the pilot as a safety measure. A dirty pilot orifice or a draft pulling the flame away from the sensor can cause the same thing. A contractor can test the thermocouple's reading and replace it if it is weak, which is usually a quick fix.
- Can a tankless water heater be repaired?
- Yes, most tankless water heater problems are repairable rather than a reason to replace the unit. Common issues are a scaled-up heat exchanger, a failed igniter, or an error code pointing to a flow sensor or flame sensor. A contractor can pull the fault code from the unit's display and diagnose which part is causing it. Tankless units are built with serviceable parts, so replacement is usually only needed when the heat exchanger itself has failed.