Water Heater Repair in Delta, UT
Tell us what your water heater is doing, and a licensed contractor who covers Millard County will get in touch.
Tell us about the job
It takes about a minute.
Winter storms and cold nights put your water heater to work
Winter nights in Delta average 20°F from December through February, and the water coming into your tank is just as cold. The tank has to work harder to bring it up to temperature, and that extra strain shows up first in the heating element or the burner assembly, whichever your unit has.
Millard County has had 32 winter storms in the last ten years, and storms like these knock out power. If your water heater is electric, an outage stops it working until power comes back, and you will notice when the hot water runs out and stays cold longer than you expect.
- 20°F
- the average winter night, and colder incoming water means longer heating
- 8 months
- October through May, the months homes here need heat
- 7%
- of Utah households lost power for a day or more in 2024, and a heater with an electric element or electric ignition stops without it
NOAA nClimDiv, 1991–2020 normals
A new water heater would cut about $80 a year off hot water for a typical Utah home.
Estimates for a typical Utah home, compared with an older unit built to the federal minimum, from EIA household energy data and Utah fuel prices. Your home will differ.
Repair makes sense when an element, thermostat or gas valve has failed.
Replacement makes sense when the tank itself is leaking.
- Why is my water heater leaking from the bottom?
- Most often the tank itself has rusted through from the inside and is failing. Water heaters have a steel tank with a glass lining, and once that lining cracks the steel underneath starts to corrode. A leak from the bottom can also come from the drain valve or a loose fitting, which a contractor can check before assuming the tank is done. If it is the tank, it needs to be replaced, not repaired, since there is no way to patch it from the inside.
- Why won't the pilot light on my water heater stay lit?
- A pilot that won't stay lit is usually a sign the thermocouple has worn out. That's the small sensor that sits in the flame and tells the gas valve it's safe to keep the gas flowing. When it wears out, it can't hold that signal, so the valve shuts the gas off and the pilot goes out. It can also mean a draft is blowing the flame out or the gas valve itself is failing, so it's worth having a contractor check which one it is before replacing parts.
- Can a tankless water heater be repaired?
- Yes, most tankless water heater problems can be repaired without replacing the unit. Common issues are a clogged inlet filter, a buildup of scale on the heat exchanger, or a failed igniter, and all of those can be serviced. Error codes on the display usually point straight to the problem, which makes diagnosis quicker than on a tank model. Replacement is usually only needed when the heat exchanger itself has cracked or corroded through.