Furnace Installation in Beaver, UT
A new furnace here will run from October through May every year. Tell us about the house, and a licensed contractor who covers Beaver County will get in touch.
Tell us about the job
It takes about a minute.
Eight months of heat, on nights that drop to 19°F
Beaver County needs heat running from October through May. That is eight months a year the burner is working, not just a stretch in the coldest weeks. Winter nights average 19°F from December through February, and most homes here heat with gas.
Any new non-weatherized gas furnace has to reach 80.0 percent AFUE at minimum, so that is the floor to start from. The county has seen 35 winter storms and 49 damaging wind events over the past ten years, and statewide, 7 percent of households went at least 24 hours without power in 2024. Worth asking whether a new furnace needs outside power to restart, before one of those nights tests it.
- 8 months
- October through May, your furnace is on duty
- 19°F
- the average winter night it heats against
- 60%
- of homes here heat with gas, so most furnaces here burn gas
- 80% AFUE
- the federal minimum any new unit must meet
NOAA nClimDiv, 1991–2020 normals
A high-efficiency gas furnace would save about $100 a year to run in Beaver County compared with a gas furnace.
Estimates for a typical Beaver County home, from EIA household energy data, Utah fuel prices and NOAA climate normals. Your home will differ.
Utah requires HVAC contractors to hold a state license.
Utah's Division of Professional Licensing issues that license, and it covers the contractor, not the job in front of you. There is one exception worth knowing. Work under $7,000 does not need a licensed contractor at all. A furnace installation runs well past that line, so the license applies here.
The license is what stands behind the person doing the work, but it is not the only check on this job. A furnace runs on gas, and a bad connection is the dangerous part of an installation. In most cities and counties, replacing a furnace needs a permit from the local building office and an inspection once the work is done, and that is where the gas line and venting get checked, separate from anything the license covers. Most homes in Beaver County heat with gas, so that inspection is not a formality here.
Sources: Utah State Legislature · Utah Department of Commerce
- What size furnace does my house need?
- There is no answer to that without a load calculation done on your actual house. A contractor works out the right size from your square footage, insulation, window count, and ceiling height, along with how cold it gets here. Guessing based on your old furnace's size or your neighbor's house is how a lot of homes end up with a furnace that's too big, which short-cycles and wears out faster, or too small, which runs constantly and still can't keep up when it drops toward 19°F overnight.
- How do I know it's time to replace my furnace?
- If it's breaking down more than once a season, or a repair is going to cost close to what a new one would, that's usually the sign. Age matters too. A furnace working hard for 8 months of the year here puts on a lot of hours, and older units run at lower efficiency than what's required now, so they cost more to keep alive both in repairs and in gas. Uneven heat between rooms, a furnace that runs longer to hit the same temperature, or a yellow flame instead of blue are all worth having a contractor look at before you're stuck without heat on a night this cold.
- Is a high-efficiency furnace worth it?
- It depends on how long you plan to stay in the house and what you're replacing. Furnaces sold since November 2015 are already required to hit at least 80 percent AFUE, so even a standard new furnace burns less gas than an older one. A high-efficiency unit goes further than that minimum, and with 60.4 percent of homes here heating with gas across 8 months of cold weather, the difference in gas use adds up over a winter. A contractor can walk you through the options for your house and what each one means for your setup.