HVAC Repair in Beaver, UT
Homes here need heat from October through May and cooling from June through August. If your system quits, tell us what it's doing and a licensed contractor who covers Beaver County will get in touch.
Tell us about the job
It takes about a minute.
Eight months of heat, three of cooling, and long cold nights between
Your furnace in Beaver County works from October through May. That is most of the year, and on winter nights that average 19°F it runs long and often to hold the house. Every cycle means the igniter fires again, and enough cold nights in a row will find the one that is about to fail.
Summer is shorter here, just June through August, but afternoons averaging 86°F still put real load on the air conditioner during those three months. The system switches between long heating runs and short, hard cooling runs, and that back and forth is what wears out parts before their time. This county has also logged 35 winter storms and 49 damaging wind events over the last ten years, the kind of weather that knocks out power and can leave a gas furnace's igniter needing a reset before it will light again.
- 8 months
- October through May, your system heats
- 3 months
- June through August, it cools
- 19°F
- the average winter night it heats against
- 86°F
- the average summer afternoon it cools against
NOAA nClimDiv, 1991–2020 normals
A new furnace and air conditioner would cut about $120 a year off heating and cooling for a typical Beaver County home.
Estimates for a typical Beaver County home, compared with an older unit built to the previous federal minimum, from EIA household energy data, Utah fuel prices and NOAA climate normals. Your home will differ.
Repair makes sense when one part has failed.
Replacement makes sense when the furnace's heat exchanger is cracked, the air conditioner's compressor has failed, or repairs keep coming.
Utah requires HVAC contractors to hold a state license.
The Division of Professional Licensing tests and tracks the contractors who hold this license. It covers the contractor as a whole, not the specific job at your house. So the same license applies whether they are fixing a heat pump or swapping out a furnace. Utah does carve out an exception for smaller jobs. Work under $7,000 does not need a licensed contractor at all.
A heating and cooling repair can land on either side of that line depending on what the job involves. If the bill stays under $7,000, the work falls outside the license requirement, and outside the protection that comes with it. Above that amount, the license is what stands behind the work. It means the person doing the repair was tested by the state and has a record with the Division of Professional Licensing.
Sources: Utah State Legislature · Utah Department of Commerce
- Why is my heat not working?
- Most often it's the igniter, the thermostat, or the power to the furnace. Gas furnaces use an igniter to light the burners, and once that part fails, the furnace won't produce heat even though the blower may still run. Check that the thermostat is set to heat and the temperature is above room temperature, and check the breaker for the furnace. With winter nights here averaging 19°F, a furnace that's down for even a night is worth getting looked at quickly.
- Why is my system running but not cooling the house?
- The blower is moving air, but something between the air handler and your rooms isn't doing its job. A dirty filter is the most common cause, since it blocks airflow across the indoor coil and can cause that coil to freeze. A low refrigerant charge or a failing outdoor unit can also leave you with air movement but no real cooling. Check the filter first. If it's clean and the air still isn't cold, the system needs a contractor to check the refrigerant charge and the outdoor unit.
- What can I check before calling for HVAC repair?
- Start with the thermostat. Make sure it's set to the right mode, the temperature is set where you want it, and the batteries aren't dead. Next check the filter, since a clogged one restricts airflow and can cause a furnace or air conditioner to shut down or freeze up. Then check the breaker panel for a tripped breaker, and for a gas furnace, make sure the gas valve is open. If the outdoor unit isn't running, check that nothing is blocking it and that it has power. These checks take a few minutes and rule out the simplest causes before a contractor needs to look at the system itself.