Furnace Repair in Beaver, UT
Furnaces here run from October through May. If yours quits, tell us what it's doing and a licensed contractor who covers Beaver County will get in touch.
Tell us about the job
It takes about a minute.
Eight months of winter wears a furnace down
Your furnace runs from October through May here, eight months of the year. On winter nights averaging 19°F, it cycles on and off many times a night just to hold the temperature. Each start puts a small strain on the igniter and the pressure switch, and over enough winters that adds up. Most homes in Beaver County heat with gas, so when the furnace won't light, there is no backup warming the house.
Power matters too. Beaver County has seen 35 winter storms and 49 damaging wind events over the past ten years, and statewide, 7% of households lost power for a day or more in 2024. A furnace with no power will not run no matter how sound the burner is, and when the power comes back, some units need a hand getting started again.
- 8 months
- October through May, your furnace is on duty
- 19°F
- the average winter night it heats against
- 60%
- of homes here heat with gas, so most furnaces here burn gas
- 35 winter storms
- in ten years, the nights a failure hurts most
NOAA nClimDiv, 1991–2020 normals
A new furnace would cut about $110 a year off heating for a typical Beaver County home.
Estimates for a typical Beaver County home, compared with an older unit built to the previous federal minimum, from EIA household energy data, Utah fuel prices and NOAA climate normals. Your home will differ.
Repair makes sense when one part has failed and the heat exchanger is sound.
Replacement makes sense when the heat exchanger is cracked or the furnace keeps needing parts.
Utah requires HVAC contractors to hold a state license.
The license is held by the contractor, not issued per job, and it means the state has tested that contractor and keeps a record of them through the Division of Professional Licensing. Work under $7,000 falls outside that requirement, so a smaller furnace repair may not need a licensed contractor even though the state license exists for this trade.
For a furnace repair, the license is what stands behind the person working on your gas connections. Gas furnaces depend on a sound connection, and in Utah that contractor's license is the record that ties the work to someone accountable for it. In Beaver County, most homes heat with gas, which is exactly the kind of job this license is meant to cover.
Sources: Utah State Legislature · Utah Department of Commerce
- Why won't my furnace turn on?
- Most often the thermostat isn't calling for heat the way it should, or the furnace isn't getting power. Check that the thermostat is set below room temperature and has fresh batteries if it uses them. Next check the furnace switch, the one that looks like a light switch near the unit, and the breaker at your panel. If those are fine, the igniter or a safety switch may have failed, and that calls for a contractor to test.
- Why is my furnace blowing cold air?
- If air is moving but it's cold, the furnace likely isn't igniting even though the blower is running. A dirty flame sensor is a common cause. It's supposed to prove the flame is burning, and when it's coated with residue it can shut the gas off right after ignition, so you get airflow without heat. This isn't something to clean yourself. A furnace that's 8 months a year on duty here needs that sensor checked before the cold really sets in.
- Why won't my furnace pilot light stay lit?
- A pilot that won't stay lit usually points to the thermocouple. That's the small sensor that sits in the pilot flame and tells the gas valve it's safe to stay open. When it wears out or sits slightly out of position, the valve reads no flame and shuts the gas off, even though the pilot was burning a second ago. A draft blowing across the pilot can do the same thing. A contractor can check the thermocouple and reposition or replace it.